Insulating Your Walls
Properly insulated walls will reduce heating and cooling loss and increase savings* for the life of the home. And insulating your walls also helps control noise transmission from room to room.
What’s your R-value?
Below are the U.S. Department of Energy recommended minimum R-values for your climate zone.
Your Climate Zone: 4
|Attics||2x4 Walls||2x6 Walls||Floors||Crawlspaces|
|Zone||4||R38 to R60||R13 to R15||R19 to R21||R25 to R30||R25 to R30|
Choosing the Right Insulation
Fiberglass insulation is sold in roll and batt form; both are available with or without kraft paper facing. Use the guide below to select the best insulation for your project.
- Easy to transport
- Must be cut to length
- Pre-cut for fast installation
- Preferred for new installation
- Kraft paper vapor retarder attached
- Use as first layer/new construction
- No vapor retarder
- Use when adding to existing insulation
To calculate how much you need:
Calculate Your Square Footage
Enter the square footage associated with your walls below.
The following products are recommended for use in walls. Add items to your list, and you’ll be able to view, print or email your checklist when you’re done.
Insulation should fit snugly within the framing cavity without any gaps or voids between the edges of the batt and the framing members. Even the smallest openings between framing members should be insulated.
2" x 6" Walls
For optimum thermal performance, walls with 2" x 6" framing should be filled with R-21 high-density insulation. 5½" thick R-21 high-density insulation delivers 19% more R-value than 6¼" R-19 fiberglass insulation.
2" x 4" Walls
For optimum thermal performance walls with 2" x 4" framing should be filled with R-15 high-density insulation. 3½" thick R-15 high-density insulation delivers 36% more R-value than standard R-11 fiberglass insulation.
Insulating walls of existing homes is a difficult task. Either insulating from the outside or inside requires removal of the existing materials. Another option for this project is to use the AttiCat® Blown-In Wall System solution in existing homes.
Interior walls may be insulated and help reduce noise transmission between rooms. Installing insulation in your interior walls can offer you quieter, more peaceful living conditions. Use unfaced insulation for your interior wall application.
NOTE: Do not leave faced insulation exposed. The facings on kraft-faced insulation will burn and must be installed in substantial contact with an approved interior finish as soon as the insulation has been installed. Facing must be installed in substantial contact with an approved ceiling, floor or wall material. Keep open flame and other heat sources away from facing. See package for warnings, fire hazard and instructions, or call 1-800-GET-PINK®. Check your local building codes for requirements in your area.
- Tape measure
- Utility knife
- Straightedge or 2 x 4 (for cutting insulation)
- Lightweight, squeeze-type stapler
- Work gloves
- Loose-fitting, long-sleeved shirt
- OSHA-approved safety glasses
- Disposable dust mask
- Portable work light
Before you begin any insulation project make sure you:
- Seal any open penetrations
- Gather the necessary tools and wear protective gear listed above
- Always use a portable work light to ensure you have enough light in your work environment
- Leave EcoTouch® PINK® insulation in its wrapper until you are ready to use it
- Packaged insulation is highly compressed and expands greatly when the wrapper is opened
Owens Corning is fully committed to safety and believes accidents are preventable. Please join us by promoting safety where you live and work.
* Savings vary. Find out why in the seller’s fact sheet on R-values. Higher R-values mean greater insulating power.