Insulating Your Crawlspace Walls
An under-insulated crawlspace can be a source of home heating and cooling loss. The best crawl space insulation for your home depends on if your crawlspace is conditioned (heated or cooled by a furnace or air conditioner) or unconditioned.
In a vented or unconditioned crawlspace, only the floor is insulated. In a heated crawl with uninsulated pipes or ducts, the walls need to be insulated and a polyethylene vapor retarder installed across the entire floor space of the crawl.
What’s your R-value?
Below are the U.S. Department of Energy recommended minimum R-values for your climate zone.
Your Climate Zone: 4
|Attics||2x4 Walls||2x6 Walls||Floors||Crawlspaces|
|Zone||4||R38 to R60||R13 to R15||R19 to R21||R25 to R30||R25 to R30|
Choosing the Right Insulation
Fiberglass insulation is sold in roll and batt form; both are available with or without kraft paper facing. Use the guide below to select the best insulation for your project.
- Easy to transport
- Must be cut to length
- Pre-cut for fast installation
- Preferred for new installation
- Kraft paper vapor retarder attached
- Use as first layer/new construction
- No vapor retarder
- Use when adding to existing insulation
To calculate how much you need:
Calculate Your Square Footage
The following products are recommended for use in crawlspace walls. Add items to your list, and you’ll be able to view, print or email your checklist when you’re done.
- First measure and cut small pieces of insulation and fit them snugly into the band joist or the area above the foundation wall.
- For the walls, the insulation should be cut long enough to cover the entire wall and extend 2' along the ground on the floor of the crawlspace. Use furring strips or cap nails to hold the insulation in place by nailing them to the sill.
- After the insulation has been installed, a 4- or 6-mil polyethylene ground cover should be placed over the entire crawl space floor. All joints / seams in the poly should be overlapped a minimum of 6" and sealed. The ground cover should run under the insulation and up the crawl space wall, on all sides, a minimum of 6" and be sealed to the wall.
NOTE: Check your local building codes for requirements in your area.
- Tape measure
- Utility knife
- Straightedge or 2 x 4 (for cutting insulation)
- Lightweight, squeeze-type stapler
- Work gloves
- Loose-fitting, long-sleeved shirt
- OSHA-approved safety glasses
- Disposable dust mask
- Portable work light
Before you begin any insulation project make sure you:
- Seal any open penetrations
- Gather the necessary tools and wear protective gear listed above
- Always use a portable work light to ensure you have enough light in your work environment
- Leave EcoTouch® PINK® insulation in its wrapper until you are ready to use it
- Packaged insulation is highly compressed and expands greatly when the wrapper is opened
Owens Corning is fully committed to safety and believes accidents are preventable. Please join us by promoting safety where you live and work.